Product Description
An easy-build, easy to fly, laser-cut, four-channel basic trainer for 3S electric power systems
Key FeaturesLightweight balsa and ply construction.
High quality laser-cut parts.
Pre-profiled control surfaces.
Docile flying characteristics.
Easy and satisfying to build.
Damage-limiting banded wing.
Full four-channel control.
High-lift Clark-Y wing section.
Full-size plan included.
What's in the Box1x Laser-cut balsa parts set.
1x Strip wood bundle for spars and longerons.
1x Hardware pack (horns, hinges etc.).
1x Piano wire undercarriage and wheel set.
1x Wing band pack.
1x Decal sheet.
1x Sandpaper sheet.
1x Full-size plan.
1x Comprehensive step-by-step instruction manual.
Needed to Complete1x 2212 1250KV brushless motor.
1x 30A ESC.
1x 8x4" EP propeller.
1x 3S 1800-2200mAh Li-Po pack.
1x 4-channel Tx / Rx combo.
4x Hitec HS-55 servos.
1x Roll of Oracover heat-shrink film.
There can be no better introduction to the hobby than one which involves building and flying your own trainer? Few would argue with that although traditional balsa trainer kits are few and far between these days, which is why the DPR Aviator is so welcome. Spanning 1160mm for a 3S powertrain it ticks all the crucial boxes that beginners need to consider, not least ease of construction, ease of transport and forgiving flying characteristics. Sure enough, with a slab-sided fuselage, flat-bottom section and flat tail surfaces the build couldn’t be simpler. Meanwhile, banded wings not only assist storage and transportation, they’re designed to ‘give’ a little when inevitable ‘arrivals’ occur during the training process. Where flying is concerned, we’d like to think of the piloting process as being more akin to gentle control intervention than the constant attention that less suitable training aircraft often require. In this respect the Aviator engenders a relaxed atmosphere to training, one that will see your ability and confidence grow exponentially.
Beautifully presented with high-quality, lightweight, laser-cut balsa and ply parts, a full-size plan, step-by-step instructions and a slot-together assembly technique, an enjoyable build is guaranteed whether you're completely new to the hobby or a wily old hand.
Product Length 810mm 31.89in
Product Wingspan 1,160mm 45.67in
Product Wing Area 22dm2 341.00in2
Completion Level Kit
Experience Level Beginner
Recommended Usage Environment Designated R/C model flying site
Material Wood
01633 682795 Mon-Fri 9:30am-4pm 
